Sentinel Controller

An in-vehicle touchscreen that runs the Sentinel system — lighting control, scenes and system status — and puts vehicle diagnostics on the same screen.

In development

One screen for the whole system

The Controller is the Sentinel system's dash interface. No laptop, no phone — the state of the vehicle's lighting and power lives where the driver can see it.

Lighting control — every Sentinel output, grouped and labelled the way the installer built it.
Scenes — one touch recalls a full lighting configuration: response, scene lighting, cruise, off.
System status — output states, currents and faults from every module on the network.

DTC display — vehicle trouble codes shown on screen, read through a connected In-Site reader.
Code clearing — with an In-Site reader connected into the system, DTCs and the check-engine light can be cleared from the Controller — with confirmation steps, not a stray tap.
CAN-native — the Controller is a citizen of the Sentinel network, not an accessory bolted onto it.

Better with In-Site

The Controller shows what the Sentinel system is doing. Connect an In-Site reader and it also shows what the vehicle is doing — live data and trouble codes, on the same screen the crew already uses.

How In-Site connects →

Built for gloves and glare

It's a working screen for working vehicles: big targets, high-contrast status, and the information a driver or officer actually needs at a glance. Detailed hardware specifications publish as the Controller clears development.